Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
11. Remove the heater/air distributor case screw, that is located above the fuel filter, from the engine compartment side of the bulkhead.
12. Have an assistant support the heater/air distributor case from inside the vehicle.
13. Remove the heater/air distributor case screws from the evaporator flange on the engine compartment side of the bulkhead. The heater/air
distributor case assembly will start to drop.
14. Pull the case straight away from the bulkhead.
15. Remove the heater/air distributor case assembly from the vehicle.
Installation Procedure
