Charade L4-1295cc 1.3L (1989)
Harness Clamp And Ground Wire
16.
Reconnect the oxygen sensor wiring harness to the clamp.
17.
Install the engine ground wiring harness to the cylinder head cover. (Radio tuner equipped model only).
Tightening Torque:
0.3 - 0.5 kg-m (2.2 - 3.6 ft-lb, 3.0 - 4.9 Nm)
18.
Connect the PCV hoses.
19.
Connect the spark plug wires to the spark plugs. Then, connect the spark plug wires to the clamp.
NOTE: Be careful not to damage the rubber grommet of the spark plug wire.
20.
Installation of timing belt.
CAUTION:
^
Do not try to pry the timing belt with a screwdriver or the like.
^
Do not allow the belt to come into contact with oil, water or dust.
^
Do not bend the belt at a sharp angle or turn the belt inside out.
^
Perform the engine turning operation at the crankshaft side.
^
Do not utilize the tension of the timing belt when tightening the set bolt of the timing belt pulley.
^
When the timing belt is reused, install the timing belt in such a way that the direction of the arrow put during the removal may match with the
engine rotation direction.
^
The adjustment of belt tension should be made when the cylinder block and its ambient temperatures are in between 5 - 50°C (41 - 122°F).
