Avenger V6-3.5L (2008)
11. Inspect the shock assembly components for the following and replace as necessary:
-
Inspect the shock absorber (damper) (13) for shaft binding over the full stroke of the shaft.
-
Inspect the jounce bumper (8) for cracks and signs of deterioration.
-
Inspect the dust shield (9) for cracks and tears.
-
Check the upper mounting bracket (4) for cracks and distortion and its retaining studs for any sign of damage.
-
Inspect the upper (3) and lower (6) bushings for material deterioration and signs of deterioration. Inspect the sleeve (5) for wear and distortion.
-
Inspect the upper (10) and lower (12) spring isolators for material deterioration and distortion.
-
Inspect the coil spring (11) for any sign of damage to the coating.
NOTE: For reassembly, See: Assembly
Assembly
ASSEMBLY
NOTE: If the coil spring has been removed from the spring compressor, proceed with the next step, otherwise, proceed with STEP 3.
1. Place the coil spring in the spring compressor following the manufacturer's instructions.
2. Slowly compress the coil spring until enough room is available for shock assembly reassembly.
3. Assemble the bushings (3, 6) and sleeve (5) through the upper mounting bracket (4).
4. Install the upper spring isolator (10) on the upper mounting bracket (4).
5. Install the upper mounting bracket (4) on top of the coil spring (11).
6. Install the lower spring isolator (12) on the spring seat of the shock absorber (13).
7. Slide the dust shield (9), jounce bumper (8) and washer (7) onto the shock rod.
