B250 3/4 Ton Van V8-318 5.2L VIN T FI (1992)
Window Regulator: Service and Repair
Power Window Regulator Replacement
POWER WINDOW GLASS REGULATOR REMOVAL
1. Remove the door trim panel and the waterdam.
2. Open the window glass (move the glass down into the door).
Vent Window
3. Remove the vent window. If necessary, refer to the removal procedure.
4. Slide the glass forward until the channel separates from the window regulator arm roller.
5. Lower the glass and channel to the bottom of the door.
Power Window Glass Regulator
6. Remove the center of the regulator retaining rivets with a drift punch and then drill them out with a 6 mm (1/4 in) diameter drill bit. When
installed, the regulator should be retained on the door inner panel with 1/4-20 x 1/2 bolts and nuts.
7. Disconnect the regulator motor wire harness connector.
8. Remove the power regulator from the door.
INSTALLATION
