Caliber L4-2.4L (2009)
1. Connect the left rear floor distribution duct (1) and the right rear floor distribution duct (2) as required to the HVAC housing (3). Make sure the
ducts are fully engaged to the housing.
2. Install the rear seat floor ducts (refer to REAR SEAT FLOOR DUCTS).
3. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Installation.
REAR SEAT FLOOR DUCTS
NOTE: Right side rear floor duct shown. Left side duct similar.
NOTE: LHD model shown. RHD model similar.
1. Connect the rear seat floor duct (2) to the rear floor distribution duct (3). Make sure the ducts are fully engaged to each other.
2. Engage the retainer that secures the rear seat floor duct to the floor support (4) and install the retaining screw (1). Tighten the screw to 2.2 Nm (20
in. lbs.).
3. Reinstall the carpet See: Body and Frame/Interior Moulding / Trim/Carpet/Service and Repair/Carpet - Installation.
4. Install the front seat to the side of the vehicle being serviced See: Body and Frame/Seats/Service and Repair/Seat - Installation.
5. Install the center floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center Console - Installation.
