Caliber L4-2.4L (2009)
Air Register: Service and Repair
Air Outlet - Installation
Beverage Cooler
BEVERAGE COOLER
NOTE: LHD model shown. RHD model similar.
1. Position the beverage cooler outlet (3) to the top of the storage bin and engage the four retaining tabs (4) by sliding the outlet toward the center of
the instrument panel top cover (1). Make sure the tabs are fully engaged.
2. Connect the hose (2) to the beverage cooler outlet.
3. Install the instrument panel top cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel Cover - Installation.
Instrument Panel
INSTRUMENT PANEL
NOTE: LHD driver side air outlet shown. RHD and passenger side outlet similar.
NOTE: Take the proper precautions to protect the faces of the instrument panels and covers from cosmetic damage while performing this
procedure.
NOTE: If the foam seal on the air outlet is deformed or damaged, it must be replaced.
1. Position the air outlet (2) onto the steering column opening cover or IP base panel (3) and install the four screws (1). Tighten the screws to 2 Nm
(17 in. lbs.).
NOTE: Make sure the foam seal on the air outlet is properly positioned into the IP duct to prevent air leaks and excessive noise during
