Challenger V6-3.5L (2009)
Cruise Control Switch: Service and Repair
Speed Control Switch - Removal
REMOVAL
WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to electrical restraint system for service
procedures. Failure to do so may result in accidental deployment of the airbag and possible serious personal and/or fatal injury
may result.
NOTE: Position the front wheels straight ahead.
1. Disconnect and isolate the negative battery cable before beginning steering wheel removal. Allow the front airbag system capacitor to discharge
for two minutes before removing the steering wheel or any front airbag system component.
2. Remove the driver airbag (3) See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Air Bag - Removal.
3. Disconnect the speed control switch electrical connector (2).
4. Remove the screw (1) from the front of the speed control switch (3).
5. Remove the screws (1) from the rear of the speed control switch (2).
6. Remove the speed control switch (2) from the steering wheel.
