Challenger V6-3.5L (2009)
Audible Warning Device: Description and Operation
Chime/Buzzer - Description
DESCRIPTION
CHIME WARNING SYSTEM
The chime warning system uses an electromechanical transducer and an electromechanical relay that are soldered onto the electronic circuit board inside
of the Cab Compartment Node (CCN). The system provides an audible indication of various vehicle conditions that may require the attention of the
vehicle operator or occupants. The CCN also includes the hardware and software necessary to serve as the electronic body control module and is
sometimes referred to as the Cab Compartment Node or CCN.
The electromechanical transducer generates beep tones and chime tones, while the electromechanical relay generates click tones to emulate the sounds
associated with conventional turn signal and hazard warning flasher operation. The microprocessor-based CCN utilizes electronic chime request
messages received from other modules in the vehicle over the Controller Area Network (CAN) data bus along with hardwired inputs to monitor many
sensors and switches throughout the vehicle. In response to those inputs, the circuitry and programming of the CCN allow it to control the audible
outputs that are produced through its on-board transducer and relay.
