Challenger V6-3.5L (2009)
4. Install the propeller shaft flange onto the output shaft and install an new flange nut. Tighten the flange nut to 200 Nm (147 ft.lbs.).
5. Stake the output shaft nut to the output shaft as follows. Place the Staking Tool 9078 (2) and Driver Handle C-4171 onto the output shaft.
6. Rotate the Staking Tool 9078 (2) until the alignment pin (3) engages the output shaft notch (4).
7. Press downward on the staking tool until the staking pin (3) contacts the output shaft nut flange (2).
8. Strike the Driver handle C-4171 with a suitable hammer until the output shaft nut is securely staked to the output shaft.
9. Install the propeller shaft See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Propeller Shaft - Installation.
