Challenger SRT-8 V8-6.1L (2009)
Outer Tie Rod
OUTER TIE ROD
CAUTION: When rotating inner tie rod, use care not to twist bellows at inner tie rod. Remove clamp at inner tie rod and make sure bellows
moves freely before rotating inner tie rod.
1. Thread outer tie rod (5) onto inner tie rod (4). Install outer tie rod using same number of turns as when removed.
2. Install outer tie rod end (5) into steering knuckle (2). Install and tighten nut (1) to 85 Nm (63 ft. lbs.).
3. Install tire and wheel assemblies (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) (Police - 190 Nm (140 ft. lbs.)) See: Wheels and
Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation.
4. Lower vehicle.
5. Perform wheel alignment setting toe to specifications See: Alignment/Service and Repair.
