Charger V6-3.5L (2009)
Muffler: Service and Repair
Installation
INSTALLATION
1. Position front exhaust pipe module clamps (2) on exhaust pipe assembly.
2. Install exhaust pipe assembly into catalytic converters (3 and 4).
NOTE: Isolators will have an approximately 10° forward angle when installed.
3. Install isolators.
4. 5.7L/6.1L Engine - Install LH rear resonator and tailpipe assembly .
5. Check for proper alignment and clearance to underbody and engine compartment components before tightening clamps.
6. Tighten band clamps to 61 Nm (45 ft. lbs.).