Charger V6-3.5L VIN G (2006)
CAUTION: It is important to tighten nut as described in following step to avoid damaging ball stud joint.
4. Place upper ball joint stud (1) through hole in top of knuckle and install nut (4). Tighten nut by holding ball joint stud with a hex wrench while
turning nut with a wrench. Tighten nut using crow foot wrench on torque wrench to 47 Nm + 90° turn (35 ft. lbs. + 90° turn) torque.
CAUTION: It is important to tighten nut as described in following step to avoid damaging ball stud joint.
5. Tighten lower ball joint nut (4) by holding ball joint stud with a hex wrench while turning nut with a wrench. Tighten nut using crow foot wrench
on torque wrench to 68 Nm + 90° turn (50 ft. lbs. + 90° turn) torque.
CAUTION: It is important to tighten nut as described in following step to avoid damaging ball stud joint.
6. Place outer tie rod stud through hole in knuckle (3) and install nut (1). Tighten nut by holding stud with a wrench while turning nut with another
wrench. Tighten nut using crow foot wrench on torque wrench to 85 Nm (63 ft. lbs.) torque.
7. Install brake rotor, then disc brake caliper and adapter assembly.
