Charger SRT-8 V8-6.1L VIN W (2006)
5.
Clean any dirt from rear fascia (Fig. 2).
6.
Remove tape backing from the new fascia seal.
7.
Apply the new fascia seal in the area shown (Fig. 2).
8.
Install the tail lamp assembly. Refer to the detailed service information available in TechCONNECT under: Service Info Group 8 - Electrical,
Lamps/Lighting - Exterior, Tail Lamp Unit, Installation.
9.
Repeat Step # 4 through Step # 8 for the opposite side of the vehicle.
10.
Remove both of the old deck lid inner bumpers from the deck lid (Fig. 3).
11.
Install two (2) new deck lid inner bumpers on the deck lid (Fig. 3).