Dakota 2WD V8-4.7L VIN J (2005)
4. Position clutch disc with pressure plate (2) on the flywheel (1).
5. Insert alignment tool (3) or spare input shaft through clutch disc and into pilot bearing.
6. Install cover bolts finger tight.
7. Tighten cover bolts evenly (and in rotation) a few threads at a time. Cover bolts must be tightened evenly and to specified torque to avoid
distorting cover.
8. Tighten cover bolts to:
-
5/16 inch bolts to 23 Nm (17 ft. lbs.).
-
3/8 inch bolts to 41 Nm (30 ft. lbs.).
9. Apply light coat of Mopar high temperature bearing grease to splines of transmission input shaft and to release bearing slide surface of front
bearing retainer.
CAUTION: Do not over-lubricate shaft splines. This could result in grease contamination of disc.
10. Install transmission as assembly.
