Dakota 4WD V8-4.7L VIN N (2000)
INSTALLATION
1. Position the glove box to the instrument panel with the bin inserted in the glove box opening far enough so that the rubber stop bumpers located on
each side of the bin are behind the metal stops located on the bracket on each side of the glove box opening.
2. Starting on the outboard side of the glove box, insert the first glove box hinge hook over the first hinge pin on the instrument panel.
3. Use a slight twisting action on the glove box door to insert the second hinge hook under the second hinge pin.
4. Finally, again using a slight twisting action on the glove box door, insert the last hinge hook over the last hinge pin.
5. Install and tighten the center screw in the bottom of the glove box bin. Tighten the screw to 2.2 Nm (20 in. lbs.).
6. Close the glove box, then reopen it to check for proper hinge operation.
7. Reconnect the battery negative cable.
