Dakota 4WD V8-4.7L VIN P Flex Fuel (2007)
Air Bag Deactivation Indicator: Service and Repair
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Using hand pressure from the face of the instrument panel center bezel, push the indicator firmly and evenly into the mounting hole until the two
latches (2) on the top and bottom of the indicator housing (3) are fully engaged on the back of the bezel (1).
2. Reinstall the center bezel onto the instrument panel.
3. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
