Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
Clutch Pedal Assembly: Service and Repair
CLUTCH PEDAL / REMOVAL
1. Remove retaining clip securing push rod on clutch pedal (Fig. 11).
2. Slide push rod off clutch pedal pin.
3. Remove snap ring and washer attaching clutch pedal to the pivot shaft.
4. Slide pedal off pivot shaft and remove pedal.
5. Remove and inspect bushings in pedal bore. Replace bushings if worn or cracked.
INSTALLATION
1. Lubricate pedal bushings and shaft with a silicone grease or with Mopar multi-mileage grease.
2. Install bushings in pedal bore and on pin.
3. Install pedal on pivot shaft.
4. Secure pedal on shaft with washer and snap ring.
5. Apply light coating of grease to the inner diameter of the master cylinder push-rod and the outer diameter of the clutch pedal pin.
6. Connect push rod to pedal and secure rod with retaining clip.
