Durango 2WD V8-4.7L Flex Fuel (2009)
Trunk / Liftgate Switch: Service and Repair
Overhead Console Switch - Removal
REMOVAL
DURANGO
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console assembly (3), See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Overhead Console -
Removal.
3. Using trim stick C-4755 or equivalent, pry the back edge of the power liftgate switch (1) up until the two retaining tabs (2) are fully released.
4. Tilt the power liftgate switch (1) up away from the overhead console assembly (3) until the mounting tab on the opposite side of the switch
releases.
5. Remove the switch from the vehicle.
ASPEN
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console assembly (3), See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Overhead Console -
Removal.
3. Using trim stick C-4755 or equivalent, pry the side edges (4) of the overhead console assembly out until the two retaining tabs on the power
liftgate switch (5) are fully released.
4. Push the switch (5) out through the back of the overhead console (3).
5. Remove the switch from the vehicle.