Durango 2WD V8-4.7L VIN N (2001)
Blower Motor: Service and Repair
Front Blower Motor
REMOVAL
1. Remove the lower right kick panel.
2. Carefully pull carpeting back from trim panel and front cowl to gain additional clearance for blower motor assembly.
3. Remove the three screws that secure the blower motor, air spoiler, and blower wheel assembly to the heater-A/C housing
4. Pull the blower motor and wheel assembly out of the passenger compartment side of the heater-A/C housing while feeding the blower motor wire
harness, grommet and connector through the hole on the dash panel side of the housing.
INSTALLATION
1. Place the blower motor, air spoiler, and wheel assembly inside the heater-A/C housing and feed the blower motor wire harness connector through
the grommet hole in the dash panel side of the housing.
2. Pull the blower motor wiring through the hole from the dash panel side of the heater-A/C housing until the grommet is seated, while positioning
the blower motor and blower wheel assembly inside the housing.
3. Install the three screws that secure the blower motor, air spoiler, and wheel assembly to the heater- A/C housing. Tighten the screws to 2.2 Nm (20
in. lbs.).
4. Plug blower motor connections together.
5. Carefully install passenger side carpet.
6. Install lower right kick panel.
