Durango 2WD V8-5.7L Hybrid (2009)
13. Install the upper condenser/radiator seal (2) and pushpins (1).
14. Raise and support the vehicle.
15. Install the lower water pump (2) mounting bolts (5 total). Tighten the mounting bolts to 28 Nm (21ft. lbs.).
16. Install the accessory drive belt.See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal and
Replacement/Serpentine Accessory Drive Belt - Installation
17. Install the heater hoses (3) to the water pump (2).
18. Install the lower radiator hose to the water pump (2).
19. Evacuate air and refill cooling system.See: Procedures/Water Pump - Coolant Air Evacuation
20. Connect negative battery cable.
21. Perform HEV specific high voltage power up and high voltage isolation check safety procedures. See: Hybrid Drive Systems/Battery System,
Hybrid Drive/Service and Repair/Battery System - High Voltage Power Up
22. Check cooling system for leaks.See: Testing and Inspection
TPIM Coolant Pump - Removal
TPIM COOLANT PUMP
