Durango 2WD V8-5.7L Hybrid (2009)
3. Install the A/C evaporator (1) into the lower half of the HVAC housing (2). Make sure that the evaporator drain is clean and unrestricted and that
the evaporator insulator (3) is properly installed.
4. If removed, install the mode-air doors into the upper half of the HVAC housing (2).
5. Align the ends of the blend-air door pivot shafts (1) to the openings in the upper half of the HVAC housing and install the upper housing half to
the lower housing half.
6. Install the screws (4) that secure the two halves of the HVAC housing (3) together. Tighten the screws to 2.2 Nm (20 in lbs.).
7. Install the HVAC wiring harness (1). Make sure the harness is routed through all wiring retainers.
8. If removed, install the blower motor resistor or power module (2), depending on application.
9. Connect the HVAC wire harness to the blower motor resistor or power module, depending on application.
