Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
2. Install the screws (4) that secure the rear blend door actuator (2) to the rear HVAC housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the rear HVAC wire harness connector (1) to the rear blend door actuator.
4. Install the right rear quarter panel trim.
5. Reconnect the negative battery cable.
6. Initiate the Actuator Calibration function using a scan tool.
Removal
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove right rear quarter panel trim.
3. Disconnect the rear HVAC wire harness connector (1) from the rear mode door actuator (2) located on the side of the rear HVAC housing (3).
4. Remove the screws (4) that secure the rear mode door actuator to the rear HVAC housing.
5. Remove the rear mode door actuator from the rear HVAC housing.
Installation
INSTALLATION