Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
21. Disconnect the HVAC wiring harness (1) from the blower motor resistor or power module (2), depending on application.
22. If necessary, remove the blower motor resistor or power module, depending on application.
23. Remove the HVAC wiring harness from the HVAC housing (3).
24. Remove the screws (4) that secure the two halves of the HVAC housing together.
25. Separate the two halves of the HVAC housing.
26. If necessary, remove the mode-air doors from the upper half of the HVAC housing.
27. Carefully lift the A/C evaporator (1) and insulator (3) out of the top of the HVAC housing (2).
NOTE: Front single zone system shown. Front dual zone system similar.
28. Remove the blend-air doors and linkage (1), mode-air door (2), baffle (3) and the duct plate (4) from the lower half of the HVAC housing (6).
29. If necessary, remove the floor distribution duct (5) from the HVAC housing.
Rear HVAC Housing
DISASSEMBLY
NOTE: The rear HVAC housing must be removed from the vehicle and disassembled for service of the A/C evaporator, heater core, mode-air door,
blend-air door and blower motor.