Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Throttle Cable/Linkage: Service and Repair
Installation
4.7L V-8
1. Slide accelerator cable plastic mount into bracket. Continue sliding until tab (3) is aligned to hole in mounting bracket.
2. Route accelerator cable over top of cable cam.
3. Connect cable end to throttle body bellcrank pin (snaps on rearward).
4. Slide rubber grommet away from plastic cable housing.
5. Install rubber grommet into dash panel until seated.
6. Push cable housing into rubber grommet and through opening in dash panel.
7. From inside vehicle, install clip (2) holding cable to dashpanel.
8. From inside vehicle, slide throttle cable core wire into opening (6) in top of pedal arm.
