Dynasty V6-181 3.0L SOHC (1991)
Suspension Strut / Shock Absorber: Service and Repair
Replacement
REMOVAL
1. Disconnect battery ground cable.
2. Raise and support vehicle, then remove wheel and tire.
3. Disconnect air line. See: Suspension Control ( Automatic - Electronic )/Air Line/Service and Repair
4. Disconnect solenoid and height sensor electrical connectors.
5. Relieve air pressure, then remove solenoid. See: Suspension Control ( Automatic - Electronic )/Level Control Solenoid Valve/Service and Repair
6. Remove strut damper assembly as follows:
Fig. 55 Marking Strut For Installation
a. Mark position of camber adjusting cam for proper alignment during installation.
b. Mark outline of strut on knuckle for proper alignment during installation.
Fig. 56 Strut/Damper Replacement
c. Remove cam bolt, knuckle bolt or bolts, washer plate or plates and brake hose to damper bracket attaching screw.
d. Unbolt strut assembly from upper fender panel.
e. Remove strut assembly from vehicle.
DISASSEMBLY & ASSEMBLY
NOTE: Disassembly is limited to upper mount and bearing housing. The strut shock absorber, air spring with internal height sensor, solenoid and
wiring harness are serviced as an assembly.
1. Using a suitable tool, hold retaining plate locking washer in place, then remove strut rod nut.
