Grand Caravan V6-3.3L Flex Fuel (2008)
27. Carefully snap the lower "B" post trim panel in place (Figure 1).
28. Carefully snap the front door sill plate and sliding door sill plate in place (Figure 3).
NOTE:
Install the nut and cap plug at the rear of the front driver side sill plate.
29. Using the supplied plastic tie strap, secure both harnesses together as shown in Figure 8. The power sliding door wiring harness must be routed to
the rear (in car position) of the drive motor wiring harness.
CAUTION:
Do not over tighten the tie strap.
30. Cut off the tail of the tie strap and rotate the tie strap so that the tie strap lock is tucked under the wiring harnesses.
31. Install the partially removed sliding door weather seal. Be sure to tuck the wiring harness behind the weather seal inner retaining lip.
32. Move the sliding door manually and verify that the lower hinge does not contact the weather seal and/or any portion of the wiring harnesses.
33. Repeat Section A on the passenger (right) side sliding door.
34. Connect negative battery cable and close hood.
B. Install Tie Wrap and Tab/Wedge
B. Install Tie Wrap and Tab/Wedge
