Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Hose/Line HVAC: Service and Repair
A/C Liquid Line - Rear
Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the
warnings and cautions could result in possible personal injury or death.
NOTE: On models equipped with the rear A/C system, the rear section of the front A/C liquid line also includes a hose and tube extension that connects
the front liquid line to the underbody liquid line.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system.
3. Remove the air cleaner housing from the right side of the engine compartment.
4. Disconnect the drain tube from the wiper module drain on the right side of the engine compartment.
5. Remove the A/C pressure transducer.
6. If equipped, remove the nut that secures the A/C ground strap eyelet to the weld stud on the top of the right front strut tower and remove the strap
from the stud (Figure 1).
7. Remove the bolt that secures the rear section of the front liquid line to the top of the receiver/drier.
8. Disconnect the rear section of the front liquid line from the top of the receiver/drier and remove and discard the O-ring seal.
9. Install plugs in, or tape over the opened liquid line fitting and the receiver/drier port.
10. Remove the nut that secures the A/C suction and liquid lines to the A/C expansion valve.
11. Disconnect the A/C suction and liquid lines from the A/C expansion valve and remove and discard the O-ring seals.
12. Install plugs in, or tape over the opened suction and liquid line fittings and expansion valve ports.
Figure 1 LIQUID LINE (FRONT SECTION)
