Grand Caravan V6-3.3L VIN E Flex Fuel (2007)
Windshield Washer Reservoir: Service and Repair
Installation
INSTALLATION
1. Push filler neck and front washer hose through the opening in the front fender side shield. Connect the reservoir to the body mount by lowering the
reservoir down.
2. Install the two reservoir mounting screws. Torque screws to 8.5 - 11.3 Nm (75 - 100 in.lbs.).
3. Connect the electrical body harness connectors to the washer pump motor and the fluid level sensor. Slide the red lock on the connector to the
closed or locked position.
4. Assure that washer is properly routed to prevent pinching and possible inoperative washers.
5. Install the left right front wheelhouse splash shield.
6. Install the right front wheel and tire assembly.
7. lower vehicle from hoist or jack stands.
8. Install the filler tube screw. Torque screw to 8.5 - 11.3 Nm (75 - 100 in.lbs.).
9. Connect the washer hose to the hose clip located on the front fender side shield.
10. Connect the washer hose at the in-line connector forward of the cowl grille.
11. Install the engine fresh air housing inside the engine compartment.
12. Connect the battery negative cable.
13. Verify system operation.
