Grand Caravan V6-3.3L VIN R (2005)
b. Install the right and left upper fascia bolts finger tight (Figure 6).
c. Install the right and left nuts that fastens the front fascia to the front lip of the front fender. Tighten the nut to 60 in. lbs. (7 N.m).
d. Install and tighten the two fascia-to-fender bolts.
e. Install the four screws (two on each side) that secure the right and left wheelhouse shield to the front fascia.
f.
Using new push pins if necessary, install the air dam to the lower radiator crossmember.
g. For vehicles with fog lamps, connect the electrical harness connectors to the fog lamps.
h. Continue with Step 9.
9. Inspect the right and left supplemental front airbag sensor wiring connectors.
>
If there is corrosion (white, green or black) on either terminal of the harness connectors, continue with Section B. Airbag Sensor Harness
Connector Replacement.
>
If there is no corrosion on either terminal of the harness connectors, continue with Section C. Supplemental Front Airbag Sensor Installation.
B. Airbag Sensor Harness Connector(s) Replacement
NOTE:
Only those harness connector(s) that exhibit terminal corrosion, as described in Section A, require replacement.
1. Cut off 3 inches (75 mm) of the old supplemental front airbag sensor wire harness connector as measured from the end of the sensor connector.
2. Remove about 1 inch (25 mm) of black tape from the sensor wire harness.
3. Remove 1/2 inch (13 mm) of insulation from each wire.
4. Cut the new harness connector wires so that the final length is equal to the old harness.
