Grand Caravan V6-3.8L (2009)
Integrated Accessory Switch Assembly: Service and Repair
Instrument Cluster Switch Pod - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Position the instrument panel switch pod (2) to the back of the instrument panel center bezel (1).
2. Install and tighten the two screws (3) that secure the switch pod to the center bezel. Tighten the screws securely.
3. Reconnect the wire harness connector to the back of the switch pod.
4. Reinstall the center bezel onto the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Bezel - Installation.
5. Reconnect the battery negative cable.
