Grand Caravan V6-3.8L (2009)
5. Install the two screws (6) securing the crosstalk tube protect bracket (4) to the recliner assembly (5). Tighten the screws to 2.5 Nm (22 in. lbs.).
6. Carefully twist the recliner motor (1) rearward to align the mounting bolt hole with the weld nut on the crosstalk tube protect bracket (4).
7. Install the recliner motor bolt (2). Tighten bolt to 9 Nm (80 in. lbs.).
8. Install the seat back cushion and cover assembly, See: Service and Repair/Removal and Replacement/Seats, First Row/Outer Trim Ring Panel -
Installation.
9. Install the third row power folding seat, See: Service and Repair/Removal and Replacement/Seats, First Row/Seat - Installation.
10. Perform the third row power folding seat recliner calibration, See: Testing and Inspection/Programming and Relearning. Verify proper seat
operation.
Third Row - Power Folding Seat Stow Motor
INSTALLATION
CAUTION: Damage to the seat stow motor or seat frame may result if the gear teeth on both assemblies are not aligned properly (2). The seat
must be temporarily reinstalled in the vehicle the ensure proper motor installation.
1. Position the third row seat into the vehicle.
2. Install the bolts that secure the hinges at the rear of the seat to the floor panel. Tighten the bolts to 89 Nm (66 ft. lbs.).
3. Position the stow motor (1) onto the seat frame shaft so that the motor teeth are in contact with the shaft teeth (2).
4. Grasping the seat bottom, slightly move the seat up or down until the gear teeth mesh and the motor drops into place.
