Grand Caravan V6-3.8L (2009)
3. Install the remaining manifold attaching bolts. Tighten all bolts to 23 Nm (200 in. lbs.).
4. Install heat shield (2,4) and attaching screws.
5. Install and connect upstream oxygen sensor.
6. Raise the vehicle.
7. Attach catalytic converter pipe (4) to exhaust manifold using new gasket and tighten bolts to 37 Nm (27 ft. lbs.).
8. Connect downstream oxygen sensor connector.
9. Install the belt splash shield and lower the vehicle.
10. Install the wiper module. See: Wiper and Washer Systems/Wiper Motor Linkage/Service and Repair/Wiper Arm Linkage - Installation.
11. Connect battery negative cable.
