dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Removal and Replacement|Page 6469 > < Removal and Replacement|Page 6467
Page 4
background image

8. Disconnect the rear heater-A/C wire harness (5) from the rear blower motor resistor or power module (1) (depending on application), rear blower

motor (2), rear mode door actuator (3) and the rear blend door actuator (4).

9. Release the retaining tab that secures the connector of the rear heater-A/C wire harness to the rear heater-A/C housing and remove the wire harness

from the housing.

10. Remove the rear blower motor resistor or power module (depending on application)  or See: Control Module HVAC/Service and Repair/Front

Blower Motor Power Module - Removal.

11. Remove the rear blower motor .
12. Remove the rear mode door actuator and rear blend door actuator See: Air Door/Air Door Actuator / Motor/Service and Repair/Mode Door

Actuator - Removal and See: Air Door/Air Door Actuator / Motor/Service and Repair/Blend Door Actuator - Removal.

13. Remove the 15 screws (2) and three metal retaining clips (4) that secure the two halves of the rear heater-A/C housing (3) together.
14. Release the three plastic retaining tabs (1) that secure the two halves of the rear heater-A/C housing together and separate the housing halves.

Removal and Replacement|Page 6469 > < Removal and Replacement|Page 6467