Grand Caravan V6-4.0L (2008)
d. Push the quarter trim bolster into the left quarter trim panel until the retaining clips (1) are fully seated.
8. Install the upper D-pillar trim.
a. Position the upper D-pillar trim into the liftgate opening.
b. Connect the power liftgate D-Pillar switch and third row power folding seat switch electrical connectors (3) (if equipped).
c. Carefully engage the upper D-pillar trim end tab (5) into the rear header trim plate.
d. Push the upper D-pillar trim onto the D-Pillar to engage the trim retaining clips (2).
9. Install the liftgate scuff plate.
a. Position the liftgate scuff plate (3) into the liftgate opening.
b. Carefully engage the scuff plate end tabs (4) into the left and right quarter trim panels (5).
c. Push the liftgate scuff plate down onto the liftgate opening to engage the scuff plate retaining clips (1).
10. Connect the battery negative cable.
11. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
12. Perform the power liftgate learn cycle,See: Service and Repair/Procedures/Power Liftgate Learn Cycle.
13. Verify power liftgate system operation.
