dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Blend Door Actuator - Removal|Page 7791 > < Blend Door Actuator - Removal|Page 7789
Page 4
background image

NOTE: LHD model shown. RHD model similar.

1. Disconnect and isolate the negative battery cable.
2. If equipped, remove the silencer from underneath the passenger side of the instrument panel.
3. Remove the lower glove box bin from the instrument panel.
4. Remove the lower trim panel (3) from the passenger side of the instrument panel to gain access to the mode door actuator.
5. Remove the two screws (3) that secure the mode door actuator to the bracket (2) located on the passenger side of the HVAC air distribution

housing and remove the actuator from the bracket.

6. Disengage the red locking tab and disconnect the wire harness connector (4) from the mode door actuator and remove the actuator from the

vehicle.

Rear Controls

REMOVAL

1. Disconnect and isolate the negative battery cable.
2. Remove rear heater-A/C housing (1) and place it on a workbench.
3. Disconnect the wire harness connector (2) from the rear mode door actuator (3).
4. Remove the two screws (4) that secure the rear mode door actuator to the back of the rear heater-A/C housing and remove the actuator.

Front Controls

INSTALLATION

Blend Door Actuator - Removal|Page 7791 > < Blend Door Actuator - Removal|Page 7789