Intrepid V6-3.2L VIN J (1998)
Amplifier: Service and Repair
REMOVAL - Midline And Infinity I System
Negative Battery Cable Remote Terminal
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove right under panel silencer/duct. Refer to Instrument Panel, Gauges and Warning Indicators/Instrument Panel Systems for Removal and
Installation procedures.
3. Remove two retaining nuts to remote amplifier.
4. Pull amplifier inboard and then pull downward to remove from upper retaining clips.
5. Disconnect two wiring connectors.
6. Remove remote amplifier from vehicle.
INSTALLATION
-
For installation, reverse the above procedures.
REMOVAL - Infinity II System
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Inside trunk, pull the trunk liner aside (right quarter panel passenger side).
3. Remove three retaining screws
4. Disconnect two wire connectors.
5. Remove remote amplifier from vehicle.
INSTALLATION
-
For installation, reverse the above procedures.
