Intrepid V6-3.2L VIN J (1998)
Air Bag(s) Arming and Disarming: Service and Repair
Air Bag System Arming and Disarming
Negative Battery Cable Remote Terminal
Disarming
Disconnect and isolate remote negative battery terminal.
Arming
1. Connect scan tool (DRB) to Data Link connector, located on the left side of the steering column and at the lower edge of the instrument panel.
2. Turn the ignition key to ON position. Exit vehicle with scan tool. Use the latest version of the proper cartridge.
3. After checking that no one is inside the vehicle, connect the battery negative remote terminal.
4. Using the scan tool. read and record active diagnostic code data.
5. Read and record any stored diagnostic codes.
6. Refer to the Diagnostic Charts if any diagnostic codes are found in Step 5 or Step 6.
7. Erase stored diagnostic codes if there are no active diagnostic codes. If problems remain, diagnostic codes will not erase. Refer to the Diagnostic
charts to diagnose the problem. If airbag warning lamp either fails to light, or goes on and stays on, there is a system malfunction. Refer to the
Diagnostic Charts to diagnose the problem.