Intrepid V6-3.2L VIN J (1998)
3.
Remove the right I/P end cap (Figure 1).
4.
For vehicles equipped with a center console only:
A.
Remove the gear shift handle set screw and then remove the gear shift handle.
B.
Remove the console shifter bezel.
C.
Remove the right console side trim panel.
5.
Remove the right lower I/P trim panel/glove box compartment.
6.
Remove the right and left A-Pillar trim panels.
7.
Remove the upper I/P cover (Figure 1).
8.
Remove the left I/P end cap (Figure 1).
9.
Remove the left lower I/P cover (Figure 1). Disconnect the hood release cable and trunk release electrical connector and set the cover aside.
10.
Remove the left knee blocker.
11.
Remove the lip center bezel. Disconnect the heater control and traction control (if equipped) electrical connectors and set the bezel aside.
12.
For vehicles equipped with a center console only: Remove the left console side trim panel.
13.
For vehicles equipped with a center console only: Remove the console to I/P center support bracket.
14.
For vehicles equipped without a center console only: Remove the center lower I/P storage bin.
15.
Remove the two (2) center I/P lower attaching nuts (Figure 1).
16.
Remove the left (driver's) side air distribution ducts.
17.
Disconnect the brake switch electrical connector.
18.
Remove the bulkhead connector mounting screw.
NOTE:
It is not necessary to disconnect the bulkhead connector.
19.
Disconnect the airbag electronic control module (AECM) electrical connector.
