Intrepid V6-3.5L VIN K (2003)
Upper
4. Tighten bolts gradually in sequence shown in (Fig. 126)until a torque of 12 Nm (105 in. lbs.) is obtained.
5. Install right side (Fig. 122) and left side (Fig. 123) intake manifold supports.
6. Install manifold support brackets at front corners and at MTV (Fig. 124).
7. Tighten fastener attaching throttle body to support bracket.
8. Connect vacuum lines to the following:
-
Speed Control Reservoir
-
Positive Crankcase Ventilation (PCV) Valve
-
Proportional Purge Solenoid
-
Power Brake Booster
9. Connect electrical connectors to the following:
-
Short Runner Valve (SRV)(If Equipped)
-
Manifold Tuning Valve (MTV) (If Equipped)
-
Throttle Position Sensor (TPS)
-
Idle Air Control (IAC)
-
Manifold Absolute Pressure (MAP)
10. Install throttle and speed control cables to bracket and throttle arm.
11. Install air cleaner housing and inlet hose (Fig. 121). Connect Inlet Air Temperature (IAT) Sensor connector.
12. Connect negative cable to remote jumper terminal.
