Magnum SRT-8 V8-6.1L VIN 3 (2006)
Electronic Brake Control Module: Description and Operation
MODULE-ANTILOCK BRAKE
DESCRIPTION
The Antilock Brake Module (ABM) is a microprocessor-based device which monitors the Antilock Brake System (ABS) during normal braking and
controls it when the vehicle is in an ABS stop. The ABM also monitors the Electronic Stability Program (ESP) if so equipped. The ABM (3) is mounted
to the HCU (2) as part of the Integrated Control Unit (ICU). The ABM uses a 47-way connector on the vehicle wiring harness. The power source for the
ABM is through the ignition switch in the RUN or ON position. The ABM is on the CAN-C bus.
The ABM (3) is mounted to the HCU (2) as part of the Integrated Control Unit (ICU). The ABM uses a 47-way connector on the vehicle wiring harness.
The power source for the ABM is through the ignition switch in the RUN or ON position. The ABM is on the CAN-C bus.
OPERATION
The primary functions of the Antilock Brake Module (ABM) are to:
-
Monitor the Antilock Brake System (ABS) and Electronic Stability Program (ESP) for proper operation.
-
Detect wheel locking or wheel slipping tendencies by monitoring the speed of all four wheels of the vehicle.
-
Control fluid modulation to the wheel brakes while the system is in ABS or traction control mode.
-
Modulates fluid pressure to the wheel brakes to control vehicle yaw rate in ESP mode.
-
Store diagnostic information.
-
Provide communication to the scan tool while in diagnostic mode.
-
Illuminate the amber TCS/ESP indicator in the instrument cluster.
The ABM constantly monitors the ABS and ESP (if equipped) for proper operation. If the ABM detects a fault, it will turn on the amber TCS/ESP
indicator and disable the ABS or ESP if so equipped. The normal base braking system will remain operational at that time.
The ABM continuously monitors the speed of each wheel through the signals generated by the wheel speed sensors to determine if any wheel is
beginning to lock. When a wheel locking tendency is detected, the ABM commands the ABM solenoid coils to actuate. The coils then open and close the
valves in the HCU that modulate brake fluid pressure in some or all of the hydraulic circuits. The ABM continues to control pressure in individual
hydraulic circuits until a locking tendency is no longer present.
