Magnum SRT-8 V8-6.1L VIN 3 (2006)
Brake Light Switch: Adjustments
STOP LAMP SWITCH ADJUSTMENT
1. Depress and hold the brake pedal.
2. Remove the stop switch from it's bracket. To do so, rotate the stop lamp switch in a counterclockwise direction approximately 30 degrees from its
proper mounting position. Pull the switch rearward and remove it from it's mounting bracket.
3. Hold the stop lamp switch firmly in one hand. Using your other hand, pull outward on the plunger of the switch until it has ratcheted out to its fully
extended position.
4. Mount the stop lamp switch into the bracket as follows: Depress the brake pedal as far down as possible. Install the switch in it's bracket by
aligning the index key on switch with the notch in the square mounting hole of the mounting bracket. Once the switch is fully seated, rotate the
switch clockwise approximately 30 degrees to lock the switch into the bracket.
CAUTION: Do not use excessive force when pulling back on the brake pedal to adjust the stop lamp switch. If to much force is used, damage to
the stop lamp switch or striker can result.
5. Gently pull back on brake pedal until the pedal stops moving. This will cause the switch plunger to ratchet backward to the correct position.
6. Check for proper operation of the brake lamps and speed control.
