Magnum SRT-8 V8-6.1L VIN 3 (2006)
Clockspring Assembly / Spiral Cable: Description and Operation
CLOCKSPRING
DESCRIPTION
WARNING:To service any component of the SCCM, the entire assembly must be removed from the column. This must be done due to the clockspring
passing through the assembly and into the self docking connector. Failure to remove the assembly could damage the pins of the clockspring
and prevent the airbag system from operating properly.
The clockspring assembly is secured with three screws (1) onto the top of the Steering Column Control Module (SCCM) near the top of the steering
column behind the steering wheel.
The clockspring consists of a flat, round molded plastic case. Within the plastic case is a spool-like molded plastic rotor with a hub. The surface of the
rotor hub has a large center hole. Within the plastic case and wound around the rotor spool is a long ribbon-like tape that consists of several thin copper
wire leads sandwiched between two thin plastic membranes. The outer end of the tape terminates at the connector terminals that align themselves into the
SCCM self-docking connector that faces the instrument panel, while the inner end of the tape terminates at the pigtail wires and connector receptacles on
the hub of the clockspring rotor that face the steering wheel.
