Magnum SRT-8 V8-6.1L VIN 3 (2006)
Seat Sensor/Switch: Service and Repair
SEAT TRACK POSITION SENSOR
REMOVAL
1. Disconnect and isolate the battery negative cable.
WARNING: WAIT TWO MINUTES FOR THE AIRBAG SYSTEM RESERVE CAPACITOR TO DISCHARGE BEFORE
BEGINNING ANY AIRBAG SYSTEM OR COMPONENT SERVICE. FAILURE TO DO SO MAY RESULT IN ACCIDENTAL
AIRBAG DEPLOYMENT, PERSONAL INJURY OR DEATH.
2. Reach under the front edge of the front seat cushion to access the seat track position sensor (3) in a bracket (1) located on the lower outboard seat
track (5).
3. Disconnect the electrical connector (4) from the sensor.
4. Using a small screwdriver, depress the snap feature (2) and pull the sensor out of the bracket.
INSTALLATION
1. Position the seat track position sensor (3) on the end of the bracket (1) located on the lower outboard seat track (5).
2. Push the sensor firmly into the bracket until the snap feature (2) locks into place.
3. Connect the electrical connector (4) to the sensor.
WARNING:
-
DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST.
-
FOLLOWING SUCCESSFUL COMPLETION OF THE AIRBAG SYSTEM TEST PROCEDURE, THE OCCUPANT
