Mini Ram Van L4-134 2.2L SOHC VIN C 2-BBL (1987)
4.
At the engine compartment, route the harness through the speedometer cable clips to the jumper wiring assembly, PN 4362558.
*Revised Part Numbers, TSB 18-37-86, Revised December 8, 1986
FIGURE 1-D - (PN 436-2558)
5.
Coat the bare blade terminal of the body harness, PN 4331724, liberally with Mopar Multi-Purpose Grease, PN 4318063, and snap terminal
into insulator, PN 5211617, located on engine side of jumper, PN 4362558 (Figure 1-D).
NOTE:
INSULATORS SHOULD BE DISCONNECTED (SEE NOTE IN A, STEP 5). IF NOT, DISCONNECT FEMALE
INSULATOR FROM MALE INSULATOR PRIOR TO INSERTION OF TERMINAL AND BE SURE THAT WIRE
OF BODY HARNESS MATES WITH SAME COLOR WIRE OF JUMPER. RECONNECT INSULATORS.
