Neon L4-2.0L SOHC (1995)
6. Slide driveshaft back into front hub. Install steering knuckle onto the ball joint stud.
7. Install a NEW steering knuckle to ball joint stud clamping bolt and nut. Tighten the nut and bolt to 95 Nm (70 ft. lbs.).
8. Install tie rod end into steering knuckle. Start tie rod end to steering knuckle nut onto stud of tie rod end. While holding stud of tie rod end
stationary, tighten tie rod end to steering knuckle nut. Then, using a crowfoot and 11/32 socket, tighten tie rod end nut to 61 Nm (45 ft. lbs.).
9. Install braking disc back on hub and bearing assembly.
