Neon L4-2.0L SOHC (1995)
Manual Window Regulator
Power Window Regulator
11. Remove window regulator through large hole in inner door panel.
12. Remove power window motor from regulator, if so equipped. Refer to Power Window Motor/Service and Repair.
INSTALLATION
1. Install power window motor on regulator, if so equipped. Refer to Power Window Motor/Service and Repair.
2. Move window regulator into position in door and engage bolt heads into key-hole slots in inner door panel and tighten bolts.
3. Install roller channel to door panel.
4. Install bolt at rear of roller channel. Make sure that bolt is aligned to mark on inner door panel made previously
5. Tighten front and rear bolts of roller channel.
6. Install nuts holding regulator lift channel to door glass.
7. Adjust door glass as described in this section.
8. Connect wire connector to power window motor, if so equipped.
9. Install door speaker, if so equipped.
10. Install door trim panel and water shield.
