Neon L4-2.0L VIN F HO (2003)
Fluid - A/T: Service and Repair
Fluid Level and Condition Check
Procedure for Checking Fluid Level
Check the fluid level while the transmission is at normal operating temperature. this occurs after at least 15 miles (25 km) of driving. At normal
operating temperature, which is approximately 180 °F (82 °C), the fluid cannot be held comfortably between the fingers.
To check the fluid level properly, the following procedure must be used:
1. The vehicle must be on level ground.
2. The engine should be running at curb idle speed for a minimum of 60 seconds.
3. Fully apply parking brake.
4. Place the gear selector momentarily in each gear position ending with the lever in P (PARK).
5. Remove the dipstick, wipe it clean and reinsert it until seated.
6. Remove the dipstick again and note the fluid level on both sides. The fluid level should be in the crosshatch area at normal operating temperatures.
If the fluid is low, add as required into the dipstick tube. DO NOT OVERFILL.
Note: If it is necessary to check the transmission below the operating temperature, the fluid level should be between the two cold (lower) holes on
the dipstick with the fluid approximately 80 °F (27 °C) (room temperature). If the fluid level is correctly established at room temperature, it should
be between the HOT (upper) reference holes when the transmission reaches 180 °F (82 °C). Remember, it is best to check the level at the normal
operating temperature.
