Neon L4-2.0L VIN F HO (2003)
4. Install fasteners attaching heater tube assembly to cylinder head and engine block.
NOTE: Before installing transmission dipstick tube clean any residual coolant from around the area where plug was placed.
5. Remove plug from transmission dipstick tube mounting hole. Install transmission dipstick tube.
6. Reattach wiring harness to heater tube assembly.
7. Connect two heater hoses to heater tubes near battery. Ensure clamps are positioned properly to seal hoses and avoid contact with engine
components.
8. Connect PCV vacuum hose to intake manifold.
9. Install air cleaner housing and throttle body to intake manifold hose.
10. Raise vehicle on hoist.
11. Close radiator draincock.
12. Lower vehicle
13. Install battery. Connect positive battery cable. Connect negative battery cable.
14. Fill cooling system.
