Nitro 2WD V6-4.0L (2007)
a. From the "Home" screen select "System View".
b. Select "All DTCs".
c. Press "Clear All Stored DTCs" if there are any DTCs shown on the list.
11. Turn the ignition key to the "OFF" position and remove the StarMOBILE unit, StarMOBILE vehicle cable, and battery charger from the vehicle.
12. Verify windshield wiper operation.
13. Continue with Section E. Calibrate "Auto-Up" Front Windows.
E. Calibrate Auto-Up Front Windows
1. Turn the ignition to the "Run" position.
2. Regardless of current window position, move the driver side front window upward until the window stalls in the full up position. Allow the window
motor to stall for at least 2 seconds before releasing the window switch.
3. Move the driver side front window downward until the window stalls in the full down position. Allow the window motor to stall for at least 2 seconds
before releasing the window switch.
4. Move the driver side front window upward until the window stalls in the full up position. Allow the window motor to stall for at least 2 second before
releasing the window switch.
5. Repeat steps 1 through 4 to calibrate the module for the passenger side front window.
6. Verify the windows are properly calibrated by operating the "Auto-Up" feature on the windows. Repeat this procedure if the calibration failed.
