RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Yaw Rate Sensor: Service and Repair
Dynamics Sensor - Removal
REMOVAL
NOTE: If the dynamics sensor is replaced, it must be initialized using the scan tool.
1. Disconnect and isolate the battery negative cable.
2. If equipped with a center floor console, remove the console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor
Console - Removal.
3. If equipped with a 40/20/40 bench seat, remove the passenger seat See: Body and Frame/Seats/Service and Repair.
4. Disconnect the electrical connector (4) for the dynamics sensor (2).
5. Remove the three mounting nuts (1) for the sensor (2).
6. Remove the sensor (2) from the vehicle.
